Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
Either of the following conditions is met: OFF malfunction (A) or (B) or (C) and (D), or ON malfunctions
- 2 detections are necessary per driving cycle:
- 1st detection; temporary flag ON
- 2nd detection; pending fault code ON
OFF MALFUNCTION (A):
| Turbine speed - Output speed x 2nd gear ratio | 1,000 RPM or more |
OFF MALFUNCTION (B):
| Turbine speed - Output speed x 6th gear ratio | 1,000 RPM or more |
OFF MALFUNCTION (C):
| Input (turbine) speed/Intermediate shaft speed | 3.232 to 7.556 |
OFF MALFUNCTION (D):
| Input (turbine) speed/Intermediate shaft speed | 3.232 to 7.556 |
ON MALFUNCTION:
| Input (turbine) speed/Intermediate shaft speed | 1.860 to 2.289 |