DTC P0500: Vehicle Speed Sensor "A": Description
WARNING: This page is about a different variant/trim than selected.
The speed sensors detect the wheel speed and send the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a 4-pulse signal and outputs it to the TCM via the combination meter. The TCM determines the vehicle speed based on the frequency of these pulse signals.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0500 | When the ECT sensor is normal and the counter gear speed is 300 RPM or more, the vehicle speed signal is not input for 2 seconds or more. |
|