Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| The monitor will run whenever these DTCs are not present | None |
| Time after ignition switch off to ON | 3 seconds or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Either of the following conditions is met | Condition 1 or 2 |
| 1. All of the following conditions are met | Conditions (a), (b) or (c) |
| (a) Engine coolant temperature | 20°C (68°F) or more |
| (b) Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Not detected |
| (c) Time after park/neutral position switch ON to OFF | 10 seconds or more |
| 2. All of the following conditions are met | Conditions (a), (b) or (c) |
| (a) Engine coolant temperature | Less than 20°C (68°F) |
| (b) Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Detected |
| (c) Time after park/neutral position switch ON to OFF | 30 seconds or more |
| One of the following conditions are met | Condition (a), (b), (c) or (d) |
| (a). Engine speed with throttle position sensor voltage is less than 0.52 V | 2300 RPM or more |
| (b). Engine speed with throttle position sensor voltage is less than 0.84 V | 2700 RPM or more |
| (c). Engine speed with throttle position sensor voltage is less than 1.2 V | 2850 RPM or more |
| (d). Engine speed with throttle position sensor voltage is 1.2 V or more | 3250 RPM or more |
| Throttle position sensor fail (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135) | Not detected |