LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 44 (Engine Control System (1AR-FE) (Diagnostic Codes (P0010-P0365) & Circuit Tests)) >> SFI System >> DTC P0011: Camshaft Position "A" - Timing Over-Advanced or System Performance (Bank 1); DTC P0012: Camshaft Position "A" - Timing Over-Retarded (Bank 1) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different variant/trim than selected.
Monitor runs whenever following DTCs not stored P0010 (Camshaft Timing Oil Control Valve)
P0016 (VVT System - Misalignment)
P0102, P0103 (Mass Air Flow Meter)
P0115, P0117, P0118 (Engine Coolant Temperature Sensor)
P0125 (Insufficient Coolant Temperature for Closed Loop Fuel Control)
P0335 (Crankshaft Position Sensor)
P0340 (Camshaft Position Sensor)
Battery voltage 11 V or higher
Engine speed 400 to 4000 RPM
Engine coolant temperature 75 to 100°C (167 to 212°F)