Section 36 (Cooling System (1AR-FE) (Service Information)): Thermostat: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL THERMOSTAT
1. Install a new gasket to the thermostat.
2. Install the thermostat with the jiggle valve facing upward.
  
  Fig 1: Identifying Jiggle Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  The jiggle valve may be set to within 10° on either side of the prescribed position.
INSTALL WATER INLET
1. Install the water inlet with the 2 nuts.
  
  Fig 2: Identifying Water Inlet
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
CONNECT NO. 2 RADIATOR HOSE . Refer to INSTALLATION - Step 48
INSTALL GENERATOR ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL V-RIBBED BELT
HINT:

Refer to INSTALLATION
ADD ENGINE COOLANT See step 3
INSPECT FOR COOLANT LEAK . Refer to ON-VEHICLE INSPECTION - Step 1
INSTALL NO. 1 ENGINE UNDER COVER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .