DTC B1800/51: Short in Driver Side Squib Circuit; DTC B1801/51: Open in Driver Side Squib Circuit; DTC B1802/51: Short to GND in Driver Side Squib Circuit; DTC B1803/51: Short to B+ in Driver Side Squib Circuit: Description
WARNING: This page is about a different variant/trim than selected.
- The driver side squib circuit consists of the center airbag sensor assembly, spiral cable and steering pad.
- The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met.
- These DTCs are stored when a malfunction is detected in the driver side squib circuit.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1800/51 |
- The center airbag sensor assembly receives a line short circuit signal in the driver side squib circuit during primary check.
- Driver side squib malfunction
- Spiral cable malfunction
- Center airbag sensor assembly malfunction
|
- Instrument panel wire
- Spiral cable
- Steering pad (Driver side squib)
- Center airbag sensor assembly
|
| B1801/51 |
- The center airbag sensor assembly receives an open circuit signal in the driver side squib circuit.
- Driver side squib malfunction
- Spiral cable malfunction
- Center airbag sensor assembly malfunction
|
- Instrument panel wire
- Spiral cable
- Steering pad (Driver side squib)
- Center airbag sensor assembly
|
| B1802/51 |
- The center airbag sensor assembly receives a short circuit to ground signal in the driver side squib circuit.
- Driver side squib malfunction
- Spiral cable malfunction
- Center airbag sensor assembly malfunction
|
- Instrument panel wire
- Spiral cable
- Steering pad (Driver side squib)
- Center airbag sensor assembly
|
| B1803/51 |
- The center airbag sensor assembly receives a short circuit to B+ signal in the driver side squib circuit.
- Driver side squib malfunction
- Spiral cable malfunction
- Center airbag sensor assembly malfunction
|
- Instrument panel wire
- Spiral cable
- Steering pad (Driver side squib)
- Center airbag sensor assembly
|