DTC B1441/41: Air Mix Damper Control Servo Motor Circuit (Passenger Side): Procedure
WARNING: This page is about a different variant/trim than selected.
- READ VALUE USING TECHSTREAM
- Connect Techstream to the DLC3.
- Turn the ignition switch on (IG) and turn Techstream main switch on.
- Select the items below in the Data List, and read the value displayed on Techstream.DATA LIST / AIR CONDITIONER
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Air Mix Sensor Targ Pulse(P) Passenger side air mix servo motor target pulse /
Min.: 0, Max.: 255MAX. COLD: 105 (pulse)
MAX HOT: 7 (pulse)- OK
The display is as specified in the normal condition column.
Result
Result Proceed to NG A OK (Checking from PROBLEM SYMPTOMS TABLE) B OK (Checking from DTC) C
B → See step 4
C → See step 5
A: Go to next step
- REPLACE AIR MIX CONTROL SERVO MOTOR
- Replace air mix control servo motor, refer to REMOVAL - Step 2 .
NEXT: Go to next step
- CHECK DTC OUTPUT
- Check for DTC.
OK
DTC B1441/41 is not output.
NG → REPAIR OR REPLACE AIR CONDITIONING HARNESS
OK → END
- Check for DTC.
- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE AIR CONDITIONING AMPLIFIER. Refer to REMOVAL - Step 6