Steering Knuckle: Installation: Installation

INSTALL STEERING KNUCKLE
1. Using SST and a press, install a new front axle hub bearing to the steering knuckle.
  
  Fig 1: Identifying Front Axle Hub
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09950-60020
    - 09951-00810
  - SST: 09950-70010
    - 09951-07100
INSTALL FRONT DISC BRAKE DUST COVER See step 2
INSTALL FRONT AXLE HUB SUB-ASSEMBLY See step 3
INSTALL FRONT AXLE HUB HOLE SNAP RING See step 4
INSTALL NO. 1 FRONT WHEEL BEARING DUST DEFLECTOR See step 5
INSTALL FRONT LOWER BALL JOINT . Refer to INSTALLATION - Step 1
INSTALL FRONT AXLE ASSEMBLY See step 7
INSTALL FRONT DRIVE SHAFT ASSEMBLY See step 8
INSTALL FRONT LOWER SUSPENSION ARM See step 9
CONNECT TIE ROD ASSEMBLY . Refer to INSTALLATION - Step 13
INSTALL FRONT DISC . Refer to REASSEMBLY - Step 1
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY See step 12
INSTALL FRONT AXLE HUB NUT See step 13
SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY See step 14
REMOVE FRONT DISC . Refer to DISASSEMBLY - Step 14
INSPECT FRONT AXLE HUB BEARING LOOSENESS See step 4
INSPECT FRONT AXLE HUB RUNOUT See step 5
INSTALL FRONT DISC . Refer to REASSEMBLY - Step 1
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY See step 19
INSTALL FRONT SPEED SENSOR See step 20
STAKE FRONT AXLE HUB NUT See step 21
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Refer to ADJUSTMENT
CHECK FOR SPEED SENSOR SIGNAL . Refer to INSTALLATION - Step 4