Steering Knuckle: Removal: Removal

REMOVE FRONT WHEEL
REMOVE FRONT AXLE HUB NUT . Refer to REMOVAL - Step 5
SEPARATE FRONT SPEED SENSOR See step 3
SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY See step 4
REMOVE FRONT DISC . Refer to DISASSEMBLY - Step 14
SEPARATE TIE ROD ASSEMBLY . Refer to REMOVAL - Step 9
SEPARATE FRONT LOWER SUSPENSION ARM See step 7
SEPARATE FRONT DRIVE SHAFT ASSEMBLY See step 8
REMOVE FRONT AXLE ASSEMBLY See step 9
REMOVE FRONT LOWER BALL JOINT . Refer to REMOVAL - Step 10
REMOVE NO. 1 FRONT WHEEL BEARING DUST DEFLECTOR See step 11
REMOVE FRONT AXLE HUB HOLE SNAP RING See step 12
REMOVE FRONT AXLE HUB SUB-ASSEMBLY See step 13
REMOVE FRONT DISC BRAKE DUST COVER See step 14
REMOVE STEERING KNUCKLE
1. Place the bearing inner race (outside) on the front axle hub bearing.
2. Using SST, V-blocks and a press, remove the front axle hub bearing from the steering knuckle.
  
  Fig 1: Identifying Front Axle Hub Bearing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09950-60010
    - 09951-00430
    - 09952-06010
  - SST: 09950-70010
    - 09951-07100
  - SST: 09950-60020
    - 09951-00750
  NOTE:
  Keep the steering knuckle level.