Sound Signal Circuit between Stereo Component Tuner Assembly and Television Display Assembly: Procedure

1. Disconnect the E29 stereo component tuner assembly connector.
2. Disconnect the Q13 television display assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E29-10 (FRI+) - Q13-28 (R+)	Always	Below 1 Ω
   E29-9 (FRI-) - Q13-29 (R-)	Always	Below 1 Ω
   E29-8 (FLI+) - Q13-30 (L+)	Always	Below 1 Ω
   E29-7 (FLI-) - Q13-31 (L-)	Always	Below 1 Ω
   E29-10 (FRI+) - Body ground	Always	10 kΩ or higher
   E29-9 (FRI-) - Body ground	Always	10 kΩ or higher
   E29-8 (FLI+) - Body ground	Always	10 kΩ or higher
   E29-7 (FLI-) - Body ground	Always	10 kΩ or higher
   Q13-27 (SG1) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2