DTC CB-13: USB Over Current Detection: Procedure

1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
2. Turn the ignition switch off.

   HINT: 

   When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

3. Turn the ignition switch to ACC.
4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

NEXT: Go to next step 

1. Clear the DTCs, refer to DTC CHECK / CLEAR .

NEXT: Go to next step 

1. Recheck for DTCs and check if the same DTC is output again.

   HINT: 

   If DTCs are detected frequently, replace the multi-media interface ECU.

   OK

   No DTCs are output.

NG → See step   4 

OK → USB DEVICE OR "iPod" WAS DEFECTIVE 

1. Disconnect the No. 1 stereo jack adapter assembly connector.
   Fig 1: Identifying No. 1 Stereo Jack Adapter Assembly A34 Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   E34-1 - E34-4	Ignition switch ACC	5 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

NG → See step   6 

OK → See step   5 

1. Disconnect the multi-media interface ECU connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E34-1 - E35-1	Always	Below 1 Ω
   E34-4 - E35-4	Always	Below 1 Ω
   E34-1 - Body ground	Always	10 kΩ or higher
   E34-4 - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   7