LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Highlander Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Can Communication System (W/O Smart Key) (Diagnostic Codes & Circuit Tests) (Hybrid) >> CAN COMMUNICATION SYSTEM (w/o Smart Key System) >> Center Airbag Sensor Communication Stop Mode >> Procedure

Center Airbag Sensor Communication Stop Mode: Procedure

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    1. Disconnect the cable from the negative (-) battery terminal before measuring the resistance of the CAN main wire or CAN branch wire.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected, refer to INITIALIZATION .

    NEXT: Go to next step 

  2. CHECK FOR OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR ASSEMBLY CAN BRANCH WIRE) 
    1. Disconnect the D30 center airbag sensor assembly connector.
      Fig 1: Identifying D30 Center Airbag Sensor Assembly Connector
      GTY301416Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      D30-13 (CANH) - D30-22 (CANL) Ignition switch off 54 to 69 Ω
      TEXT IN ILLUSTRATION

      *a Rear view of wire harness connector
      (to Center Airbag Sensor Assembly)

    NG → REPAIR OR REPLACE CENTER AIRBAG SENSOR ASSEMBLY CAN BRANCH WIRE OR CONNECTOR (CANH, CANL) 

    OK: Go to next step 

  3. CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY - BATTERY AND BODY GROUND) 
    1. Connect the cable to the negative (-) battery terminal.
      Fig 2: Identifying D30 Center Airbag Sensor Assembly Connector
      GTY301560Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected, refer to INITIALIZATION .

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      D30-25 (E1) - Body ground Always Below 1 Ω
      D30-26 (E2) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Switch Condition Specified Condition
      D30-21 (IG2) - Body ground Ignition switch ON 11 to 14 V
      TEXT IN ILLUSTRATION

      *a Rear view of wire harness connector
      (to Center Airbag Sensor Assembly)

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   4 

  4. REPLACE CENTER AIRBAG SENSOR ASSEMBLY. Refer to  REMOVAL 
scientia non olet · About LEMON Manuals