On-Vehicle Inspection

1. Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.
   REFERENCE: MPH (FOR U.S.A.)
   
   

   Chassis Dynamometer Indication (mph)	Acceptable Range (mph)
   20	20.0 to 23.0
   40	40.0 to 43.5
   60	60.0 to 64.0
   80	80.0 to 84.5
   100	100.0 to 105.0
   120	120.0 to 125.5
   140	140.0 to 146.0

   REFERENCE: KM/H (EXCEPT FOR U.S.A.)
   
   

   Chassis Dynamometer Indication (km/h)	Acceptable range (km/h) Data in () is for reference
   20	(17.5 to 21.5)
   40	38.0 to 42.0
   60	58.0 to 63.0
   80	78.0 to 84.0
   100	98.5 to 104.5
   120	119.0 to 125.0
   140	139.0 to 146.0
   160	159.0 to 167.0
   180	179.0 to 188.0
   200	199.0 to 209.0
   220	219.0 to 230.0
   240	239.0 to 251.0

   NOTE:

   Tire wear as well as over or under inflation will cause errors.

2. Check the deviation of the speedometer indication from the acceptable range.

   Reference

   Less than 0.5 km/h (0.3 mph)

   HINT: 

   If the indication is not as specified, go to Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE .

HINT: 

If the indication is not as specified, go to Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE .