LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 67 (Hybrid Vehicle Control System (P311) (Hybrid) (Diagnostic Codes (P0343-747 - P0A78-282)) >> Hybrid Control System >> DTC P0A1A-659: Generator Control Module >> Procedure

DTC P0A1A-659: Generator Control Module: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK INVERTER WITH CONVERTER ASSEMBLY (MOTOR CABLE CONNECTION CONDITION) See step   4 

    NG → TIGHTEN TO SPECIFIED TORQUE 

    OK: Go to next step 

  2. CHECK INVERTER WITH CONVERTER ASSEMBLY (GENERATOR CABLE CONNECTION CONDITION) See step   5 

    NG → TIGHTEN TO SPECIFIED TORQUE 

    OK: Go to next step 

  3. CHECK HYBRID VEHICLE TRANSAXLE ASSEMBLY (MG1) See step   6 

    NG → REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY 

    OK: Go to next step 

  4. CHECK HYBRID VEHICLE TRANSAXLE ASSEMBLY (MG2) See step   7 

    NG → REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY 

    OK → REPLACE INVERTER WITH CONVERTER ASSEMBLY 

scientia non olet · About LEMON Manuals