DTC P0AC0-123: Hybrid Battery Pack Current Sensor Circuit Range / Performance: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTCS (DTC P0A1F-123 IS OUTPUT)
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.
  Result
  
  DTC P0A1F-123 is output.
YES → GO TO INSPECTION PROCEDURE RELEVANT TO OUTPUT DTC

NO: Go to next step
REPLACE HV RELAY ASSEMBLY
Refer to REMOVAL .

NEXT: Go to next step
CLEAR DTC
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
4. Clear DTCs.
5. Perform a road test.
  HINT:
  
  Turn the power switch off and perform a road test again after the first road test for 2 trip detection.
NEXT: Go to next step
RECONFIRM DTC OUTPUT
1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.
  Result
  
  DTC P0AC0-123 is output.
YES → See step 5

NO → COMPLETED
REPLACE BATTERY SMART UNIT. Refer to REMOVAL