Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

WARNING:

Before inspecting the high-voltage system, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
After disconnecting the service plug grip, wait for at least 10 minutes before touching any of the high-voltage connectors or terminals.

HINT:

Waiting for at least 10 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.
After completing repairs, restart the system (turn the power switch on (READY)) and recheck for DTCs. Refer to DTC CHECK / CLEAR