DTC P1606-138: Collision Detection; DTC P1606-308: Collision Detection; DTC P1606-317: Collision Detection: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (HV)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
- Check if DTCs are output.
Result
DTC No. Proceed to P1606 and PA01D are output. A P1606 only is output. B
A → See step 5
B: Go to next step
- CHECK SUPPLEMENTAL RESTRAINT SYSTEM
- Troubleshoot the airbag system.
Result
There is a malfunction.
YES → REPLACE MALFUNCTIONING PARTS, COMPONENT AND AREA
NO: Go to next step
- Troubleshoot the airbag system.
- CHECK INFORMATION CODE
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
- Check if DTCs are output.
- Access the freeze frame data corresponding to DTC P1606 and select the information.
Result
INF Code Proceed to 138 A 308
(for TMC Made)B 308
(for TMMK Made)C 317 D
A → See step 6
B → See step 7
C → See step 10
D: Go to next step
- CHECK DTC OUTPUT (HV)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
- Check if DTCs are output.
Result
DTC No. Proceed to P3107 is not output. A P3107 is output. B
B → See step 8
A → See step 9
- GO TO INSPECTION PROCEDURE RELEVANT TO OUTPUT DTC (P0A1D). Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE CIRCUIT BREAKER SENSOR NO. 1. Refer to REMOVAL
- REPLACE CENTER AIRBAG SENSOR ASSEMBLY (for TMC Made). Refer to REMOVAL
- GO TO INSPECTION PROCEDURE RELEVANT TO OUTPUT DTC (P3107). Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE HYBRID VEHICLE CONTROL ECU. Refer to REMOVAL
- REPLACE CENTER AIRBAG SENSOR ASSEMBLY (for TMMK Made). Refer to REMOVAL