DTC P2759: Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU): Procedure

1. Disconnect the ECM connector.
   Fig 1: Checking Harness And Connector (Shift Solenoid Valve SLU Circuit)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E26-7 (SLU+) - E26-6 (SLU-)	20°C (68°F)	5.0 to 5.6 Ω
   E26-7 (SLU+) - Body ground and other terminals	Always	10 kΩ or higher
   E26-6 (SLU-) - Body ground and other terminals	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to ECM)

   Result

   Result	Proceed to
   OK	A
   NG	B

B → See step   2 

A → See step   6 

1. Disconnect the harness connector from the wiring harness connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E26-7 (SLU+) - E8-14 (SLU+)	Always	Below 1 Ω
   E26-6 (SLU-) - E8-5 (SLU-)	Always	Below 1 Ω
   E26-7 (SLU+) or E8-14 (SLU+) - Body ground and other terminals	Always	10 kΩ or higher
   E26-6 (SLU-) or E8-5 (SLU-) - Body ground and other terminals	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Remove the wiring harness connector from the automatic transaxle.
   Fig 2: Checking Transmission Wire (SLU)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A-11 (SLU+) - A-5 (SLU-)	20°C (68°F)	5.0 to 5.6 Ω
   A-11 (SLU+) - Body ground and other terminals	Always	10 kΩ or higher
   A-5 (SLU-) - Body ground and other terminals	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Transmission Wire)

NG → See step   4 

OK → See step   8 

1. Remove shift solenoid valve SLU.
   Fig 3: Inspecting Shift Solenoid Valve SLU

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	20°C (68°F)	5.0 to 5.6 Ω

3. Connect a battery positive (+) lead with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.

   OK

   Valve moves and makes an operating sound.

   TEXT IN ILLUSTRATION
   
   

   *1	Shift Solenoid Valve SLU

NG → See step   7 

OK → See step   5