Typical Enabling Conditions
WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
ALL
| The monitor will run whenever the following DTCs are not present | None |
| Engine switch | on (IG) |
| Starter | OFF |
CONDITION (A)
| Battery voltage | 12 V or more |
CONDITION (B)
| Battery voltage | 10 V or more and less than 12 V |
| Target current | Less than 0.75 A |
CONDITION (C)
| Battery voltage | 8 V or more |
| Target current | 0.25 A or more |