Typical Enabling Conditions
WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
GO and STOP are defined as follows;
THE STOP LIGHT SWITCH REMAINS ON DURING GO AND STOP 5 TIMES.
| The monitor will run whenever this DTC is not present. | None |
| GO: (Vehicle speed is 18.63 mph (30 km/h) or more) | 18.7 mph (30 km/h) or more |
| STOP: (Vehicle speed is less than 1.86 mph (3 km/h)) | Less than 1.86 mph (3 km/h) |
| Starter | OFF |
| Battery voltage | 8 V or more |
| Engine switch | on (IG) |