Inspection Procedure

WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform the universal trip to clear permanent DTCs. Refer to DTC CHECK / CLEAR .

HINT:

Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

READ DATA LIST

Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Turn on the tester.
Select the item "Powertrain / ECT / Data List".

According to the display on the tester, read the "Data List".

Tester Display	Measurement Item / Range	Normal Condition	Diagnostic Note
Neutral Position SW Signal	PNP switch status / ON or OFF	Shift lever position is; P and N: ON Except P and N: OFF	When the shift lever position displayed on Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
Shift SW Status (R Range)	PNP switch status / ON or OFF	Shift lever position is; R: ON Except R: OFF	When the shift lever position displayed on Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.
Shift SW Status (D Range)	PNP switch status / ON or OFF	Shift lever position is; D and S: ON Except D and S: OFF	When the shift lever position displayed on Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect.