LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Automatic Transmission - U660E - (Diagnostic Codes & Circuit Tests) (Except Hybrid)) >> Automatic Transaxle System >> DTC P062F: Internal Control Module EEPROM Error >> Procedure

DTC P062F: Internal Control Module EEPROM Error: Procedure

WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ OUTPUT DTC (DTC P062F) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Clear DTCs. Refer to DIAGNOSTIC TROUBLE CODE CHART .
    5. Turn the ignition switch off and turn the Techstream off.
    6. Disconnect the Techstream.
    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    8. Connect the cable to the negative (-) battery terminal.
    9. Connect the Techstream to the DLC3.
    10. Turn the ignition switch to ON.
    11. Turn the Techstream on.
    12. Select the following menu items: Powertrain / ECT / Trouble Codes.
    13. Read DTCs.
      RESULT

      Result Proceed to
      No output A
      P062F B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING 
  3. REPLACE TCM. Refer to  REMOVAL 
scientia non olet · About LEMON Manuals