LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (Engine Control (SFI) System (2GR-FE) (Diagnostic Codes (P0443-U0101) & Circuit Tests) (Except Hybrid)) >> SFI System >> DTC P1607: Cruise Control Input Processor >> Procedure

DTC P1607: Cruise Control Input Processor: Procedure

WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ OUTPUT DTC (DTC P1607) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Clear DTC. Refer to DTC CHECK / CLEAR .
    5. Turn the ignition switch off and turn the Techstream off.
    6. Disconnect the tester.
    7. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
    8. Connect the cable to the battery negative (-) terminal.
    9. Connect the tester to the DLC3.
    10. Turn the ignition switch to ON.
    11. Turn the Techstream on.
    12. Select the following menu items: Powertrain / Engine / Trouble Codes.
    13. Read DTCs.

      Result

      Result Proceed to
      No output A
      P1607 B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to  REMOVAL 
scientia non olet · About LEMON Manuals