Inspection Procedure
WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
According to the Data List displayed by the Techstream, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the Data List as the first step of troubleshooting is one method to shorten labor time.
NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- READ DATA LIST
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Select the item "Powertrain / Engine / Data List".
- According to the display on the tester, read the "Data List".
Item Measurement Item / Range (Display) Normal Condition Diagnostic Note Neutral Position Switch Signal PNP SW Status / ON or OFF Shift lever position is;
P and N: ON
Except P or N: OFFWhen the shift lever position displayed on the Techstream differs from the actual position, adjustment of the PNP switch or the shift cable may be incorrect. Reverse PNP SW Status / ON or OFF Shift lever position is;
R: ON
Except R: OFF↑ Drive PNP SW Status / ON or OFF Shift lever position is;
D and S: ON
Except D or S: OFF↑