DTC P0630: VIN not Programmed or Mismatch - ECM / PCM: Procedure
WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
- READ DTC OUTPUT
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Code.
- Read the DTCs.
Result
Display (DTC Output) Proceed to P0630 A P0630 and other DTCs B If any DTCs other than P0630 are output, troubleshoot those DTCs first.
NOTE:If P0630 is set, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the tester when inputting the VIN. If DTCs other than P0630 are set, check them first.
B → See step 3
A: Go to next step
- INPUT VIN WITH TECHSTREAM
NEXT → END
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART