LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (Engine Control (SFI) System (2GR-FE) (Diagnostic Codes (P0443-U0101) & Circuit Tests) (Except Hybrid)) >> SFI System >> DTC P0500: Vehicle Speed Sensor "A" >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2010 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
The monitor will run whenever these DTCs are not present None
Time after ignition switch off to ON 3 seconds or more
Engine Running
Battery voltage 8 V or more
Ignition switch ON
Starter OFF
Either of following conditions is met Condition 1 or 2
1. All of the following conditions are met Conditions A, B and C
A. Engine coolant temperature 20°C (68°F) or more
B. Engine coolant temperature sensor fail Not detected
C. Time after park/neutral position switch ON to OFF 10 seconds or more
2. All of the following conditions are met Conditions A and B
A. Either of the following conditions is met (a) or (b)
(a) Engine coolant temperature Less than 20°C (68°F)
(b) Engine coolant temperature sensor fail Detected
B. Time after park/neutral position switch ON to OFF 30 seconds or more