Entire Combination Meter does not Operate: Procedure

1. Disconnect the F1 connector.
   Fig 1: Combination Meter Assembly Wire Harness View

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   F1-12 (E2) - Body ground	Always	Below 1 Ω
   F1-24 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   F1-13 (IG+) - Body ground	Turn the ignition switch on (IG)	10 to 14 V
   F1-1 (B) - Body ground	Always	10 to 14 V
   F1-2 (B2) - Body ground	Always	10 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE COMBINATION METER ASSEMBLY