LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Service Information) (Except Hybrid) >> Steering Pad Switch >> Installation >> Installation

Steering Pad Switch: Installation: Installation

  1. INSTALL STEERING PAD SWITCH ASSEMBLY (for 4 Spoke) 
    1. Engage the 2 pins and install the steering pad switch assembly.
      Fig 1: Locating Steering Pad Switch Assembly Screw And Pins
      GTY207086Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the screw.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    3. Engage the 2 pins and install the steering pad switch assembly.
      Fig 2: Locating Steering Pad Switch Pins
      GTY207019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the screw.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    5. Connect the connector to the spiral cable.
  2. INSTALL STEERING PAD SWITCH LH (for 4 Spoke) 
    1. Engage the 2 pins and install the steering pad switch LH.
      Fig 3: Locating Steering Pad Switch Pins
      GTY207019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the screw.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    3. Connect the connector to the spiral cable.
  3. INSTALL STEERING PAD SWITCH ASSEMBLY (for 3 Spoke) 
    1. Engage the 2 pins and install the steering pad switch assembly.
      Fig 4: Locating Steering Pad Switch Assembly Screw And Clamp
      GTY207031Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the screw and engage the clamp.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    3. Engage the 2 pins and install the steering pad switch assembly.
      Fig 5: Locating Steering Pad Switch Assembly Pins And Clamp (For 3 Spoke)
      GTY207082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the screw and engage the clamp.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    5. Connect the connector to the spiral cable.
  4. INSTALL STEERING PAD SWITCH LH (for 3 Spoke) 
    1. Engage the 2 pins and install the steering pad switch LH.
      Fig 6: Locating Steering Pad Switch Assembly Screw And Clamp
      GTY207030Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the screw and engage the clamp.

      Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf) 

    3. Connect the connector to the spiral cable.
  5. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  6. INSTALL LOWER NO. 3 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 2
  7. INSTALL LOWER NO. 2 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  9. INSPECT SRS WARNING LIGHT  . Refer to INSTALLATION - Step 6
scientia non olet · About LEMON Manuals