Door LOCK Position Circuit: Procedure

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on (IG).
3. Turn Techstream on.
4. Select the following menu items: Body Electrical / Main Body / Data List.
5. Read the display on Techstream.
   MAIN BODY:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D-Door Lock Pos SW	Driver side door lock position switch signal / ON or OFF	ON: Driver side door unlocked OFF: Driver side door locked	-
   P-Door Lock Pos SW	Front passenger side door lock position switch signal / ON or OFF	ON: Front passenger side door unlocked OFF: Front passenger side locked	-
   RL-Door Lock Pos SW	Rear left door lock position switch signal / ON or OFF(*1, *3)	ON: Rear left door unlocked OFF: Rear left door locked	-
   	Rear left or right door lock position switch signal / ON or OFF(*2, *3)	ON: Rear left or right door unlocked OFF: Rear left and right door locked	-
   RR-Door Lock Pos SW	Rear right door lock position switch signal / ON or OFF(*1, *3)	ON: Rear right door unlocked OFF: Rear right door locked	-
   	Rear right or left door lock position switch signal / ON or OFF(*2, *3)	ON: Rear right or left door unlocked OFF: Rear right and left door locked	-

   HINT: 

   • *1: with Smart Key System
   • *2: without Smart Key System
   • *3: with Theft Deterrent

   OK

   Normal conditions listed above are displayed.

NG → GO TO  POWER DOOR LOCK CONTROL SYSTEM  POWER DOOR LOCK CONTROL SYSTEM 

OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  PROBLEM SYMPTOMS TABLE