Tire Pressure Warning Ecu: Installation: Installation

INSTALL TIRE PRESSURE WARNING ECU
1. Connect the connector to the tire pressure warning ECU.
  
  Fig 1: Locating Tire Pressure Warning ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the tire pressure warning ECU with the nut.
  Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf)
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made) . Refer to INSTALLATION - Step 35
INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made) . Refer to INSTALLATION - Step 36
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 37
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH . Refer to INSTALLATION - Step 46
INSTALL FRONT DOOR SCUFF PLATE RH . Refer to INSTALLATION - Step 47
CONNECT CABLE TO BATTERY NEGATIVE TERMINAL
REGISTER TRANSMITTER ID
HINT:

Refer to REGISTRATION
INITIALIZE SYSTEM
NOTE:
- Be sure to register the transmitter IDs of all tires including the grand spare tire in the ECU before initialization.
- Be sure to inflate all tires including the grand spare tire to the proper inflation pressure before initialization.
HINT:

Refer to INITIALIZATION
INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:

Refer to TEST MODE PROCEDURE