LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 436 (Automatic Transaxle (U660E) (Diagnostic Codes & Circuit Tests) (Except Hybrid)) >> Automatic Transaxle System >> DTC U0100: Lost Communication with ECM / PCM "A" >> Description

DTC U0100: Lost Communication with ECM / PCM "A": Description

WARNING: This page is about a different car, the 2013 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

The engine control unit communicates with the TCM using the Controller Area Network (CAN).

If there is a problem in this communication, the TCM sets a DTC.

DTC No. DTC Detection Condition Trouble Area
U0100 Following conditions are met for 1.25 seconds (1 trip detection logic):
  • Engine switch on (IG)
  • Battery voltage is 10.5 V or more
  • No communication between the engine control ECU (ECM) and TCM
  • Harness and connector
  • ECM
  • TCM