LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 436 (Automatic Transaxle (U660E) (Diagnostic Codes & Circuit Tests) (Except Hybrid)) >> Automatic Transaxle System >> DTC P0796: Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2013 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
ALL:

The monitor will run whenever this DTC is not present.
(Not circuit malfunction)
P0712, P0713 (ATF temperature sensor circuit (TFT sensor))
P0115, P0117, P0118 (ECT sensor circuit)
P0715, P0717 (Turbine speed sensor circuit)
P0791, P0793 (Intermediate shaft speed sensor circuit)
P0748 (Shift solenoid valve SL1 circuit)
P0778 (Shift solenoid valve SL2 circuit)
P0798 (Shift solenoid valve SL3 circuit)
P2810 (Shift solenoid valve SL4 circuit)
P0327, P0328, P0332, P0333 (KCS sensor circuit)
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135 ((ETCS) Electronic throttle control system)
U0100 (CAN communication system)
Transmission range "D"
TFT (Transmission fluid temperature) -10°C (14°F) or more
TFT (Transmission fluid temperature) sensor circuit No circuit malfunction
ECT (Engine coolant temperature) sensor circuit No circuit malfunction
Turbine speed sensor circuit No circuit malfunction
Intermediate shaft speed sensor circuit No circuit malfunction
Shift solenoid valve SL1 circuit No circuit malfunction
Shift solenoid valve SL2 circuit No circuit malfunction
Shift solenoid valve SL3 circuit No circuit malfunction
Shift solenoid valve SL4 circuit No circuit malfunction
(KCS) Knock control sensor circuit No circuit malfunction
(ETCS) Electronic throttle control system Not system down
CAN communication system Not system down
Engine Starting
OFF MALFUNCTION (A):

TCM selected gear 2nd
Throttle valve opening angle 3% or more
TCM indicated pressure value of SL1 1, 200 kPa
TCM indicated pressure value of SL2 0 kPa
TCM indicated pressure value of SL3 1, 200 kPa
OFF MALFUNCTION (B):

TCM selected gear 6th
Throttle valve opening angle 3% or more
TCM indicated pressure value of SL1 0 kPa
TCM indicated pressure value of SL2 1, 200 kPa
TCM indicated pressure value of SL3 1, 200 kPa
OFF MALFUNCTION (C):

TCM selected gear 2nd
Throttle valve opening angle:  
(When condition "D" is not detected) 4.5% or more at engine speed 2, 000 rpm (condition varies with engine speed)
(When condition "D" is detected) 0.5% or more at engine speed 750 rpm (condition varies with output speed)
ECT (engine coolant temperature) 40°C (104°F) or more
OFF MALFUNCTION (D):

Throttle valve opening angle 0.5% or more at engine speed 750 rpm (condition varies with output speed)
ON MALFUNCTION:

TCM selected gear 1st
Vehicle speed 1.2 mph (2 km/h) or more
Engine speed - Turbine speed 50 rpm or more
ECT (engine coolant temperature) 40°C (104°F) or more