DTC P0711: Transmission Fluid Temperature Sensor "A" Performance: Procedure

WARNING: This page is about a different car, the 2013 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.

CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / ECT / Trouble Codes.

Read the DTCs using the Techstream.

Result

Display (DTC Output)	Proceed to
Only P0711 is output	A
P0711 and other DTC	B

HINT:

If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.

B → See step 3

A: Go to next step

CHECK TRANSMISSION FLUID LEVEL
1. Check the transmission fluid level. Refer to ADJUSTMENT .
  OK
  
  Automatic transmission fluid level is correct.
NG → ADJUST FLUID LEVEL

OK → See step 4
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
REPLACE ATF TEMPERATURE SENSOR ASSEMBLY. Refer to COMPONENTS