LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 436 (Automatic Transaxle (U660E) (Diagnostic Codes & Circuit Tests) (Except Hybrid)) >> Automatic Transaxle System >> DTC P062F: Internal Control Module EEPROM Error >> Procedure

DTC P062F: Internal Control Module EEPROM Error: Procedure

WARNING: This page is about a different car, the 2013 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ OUTPUT DTC (DTC P062F) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Clear DTCs. Refer to DTC CHECK / CLEAR .
    5. Turn the engine switch off and turn the Techstream off.
    6. Disconnect the Techstream.
    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    8. Connect the cable to the negative (-) battery terminal.
    9. Connect the Techstream to the DLC3.
    10. Turn the engine switch on (IG).
    11. Turn the Techstream on.
    12. Select the following menu items: Powertrain / ECT / Trouble Codes.
    13. Read DTCs.
      RESULT

      Result Proceed to
      No output A
      P062F B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  ELECTRONIC CIRCUIT INSPECTION PROCEDURE 
  3. REPLACE TCM. Refer to  COMPONENTS 
scientia non olet · About LEMON Manuals