Driver Side Seat Belt Warning Light does not Operate: Procedure

1. Check for DTCs.

   Result

   Result	Proceed to
   Output DTC (CAN communication)	A
   Output DTC (Airbag system (for TMC made))	B
   Output DTC (Airbag system (except TMC made))	C
   No output DTC	D

A → See step   3 

B → See step   4 

C → See step   5 

D: Go to next step 

1. Operate Techstream according to the steps on the display and select "ACTIVE TEST".

   Combination Meter

   Tester Display	Test Part	Control Range	Diagnostic Note
   D-BELT REMIND	D-SEAT BELT indicator light	OFF/ON	Confirm that the vehicle is stopped with the engine idling

   OK

   Switch condition (ON/OFF) can be switched by "ACTIVE TEST".

NG → REPLACE COMBINATION METER ASSEMBLY 

OK → END