Installation (To 12/2010): Installation

INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
1. Connect the connector to the driver side knee airbag assembly.
  
  Fig 1: Locating Bolts And Driver Side Knee Airbag Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  When handling the airbag connector, take care not to damage the airbag wire harness.
2. Install the driver side knee airbag assembly with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
INSTALL INSTRUMENT PANEL FINISH PANEL LOWER LH
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
INSTALL FRONT DOOR SCUFF PLATE LH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization. Refer to INITIALIZATION .
  HINT:
  
  Some systems need initialization when disconnecting the cable from the negative battery terminal.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light. Refer to DIAGNOSIS SYSTEM .