LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Avalon Base >> Repair and Diagnosis >> Electrical >> Gauges >> Combination Meter (Service Information) >> Combination Meter >> INSTALLATION (To 12/2010) >> Installation

INSTALLATION (To 12/2010): Installation

  1. INSTALL COMBINATION METER ASSEMBLY 
    1. Connect the connector.
    2. Install the combination meter assembly with the 4 screws.
  2. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 30
  3. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY  . Refer to INSTALLATION - Step 31
  4. INSTALL INSTRUMENT PANEL FINISH PLATE (w/o Smart Key System)  . Refer to INSTALLATION - Step 32
  5. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL  . Refer to INSTALLATION - Step 37
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

scientia non olet · About LEMON Manuals