LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2011 >> Avalon Base >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) >> Navigation Receiver >> INSTALLATION (To 12/2010) >> Installation

INSTALLATION (To 12/2010): Installation

  1. INSTALL NAVIGATION RECEIVER ASSEMBLY 
    1. Slide the navigation receiver assembly in the direction shown by the arrow to install the navigation receiver assembly.
      Fig 1: Install Navigation Receiver Assembly
      GTY298640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 2 RADIO BRACKET 
    1. Install the No. 2 radio bracket with the 4 bolts and 2 screws.
  3. INSTALL NO. 1 RADIO BRACKET 
    1. Install the No. 1 radio bracket with the 4 bolts and 2 screws.
  4. INSTALL INTEGRATION CONTROL AND PANEL WITH NAVIGATION RECEIVER ASSEMBLY 
    1. Connect each connector.
    2. Engage the 4 clips.
    3. Install the integration control and panel with navigation receiver assembly with the 4 bolts.
  5. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL  . Refer to INSTALLATION - Step 37
scientia non olet · About LEMON Manuals