Entire Combination Meter does not Operate: Procedure

1. Disconnect the E30 connector.
   Fig 1: Identifying E30 Combination Meter Assembly Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E30-40 (E2) - Body ground	Always	Below 1 Ω
   E30-39 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   E30-1 (B2) - Body ground	Always	11 to 14 V
   E30-21 (B) - Body ground	Always	11 to 14 V
   E30-22 (IG+) - Body ground	Ignition switch on (IG)	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE COMBINATION METER ASSEMBLY