Meter / Gauge System: Initialization: Initialization

OIL MAINTENANCE WARNING RESETTING PROCEDURE
HINT:

The ODO/TRIP change switch is located below the speedometer.
1. Turn the ignition switch on (IG).
2. Press the ODO/TRIP change switch until the ODO meter appears.
3. Turn the ignition switch off.
4. Turn the ignition switch on (IG) while pressing and holding the ODO/TRIP change switch. Hold the ODO/TRIP change switch for more than 5 seconds.
  HINT:
  - If the ignition switch is turned off during the reset procedure, the odometer and the maintenance indicator go off.
  - If the reset switch is not pressed for at least 5 seconds during the reset procedure, the LCD returns to the ODO meter and maintenance indicator returns to the previous state.