Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| Monitor runs whenever following DTCs not present | None |
| Time after engine starts | 5 seconds or more |
| Battery voltage | 10.5 V or more |
| Throttle position (Throttle position sensor voltage) | 0.24 to 2 V |
| Estimated Load | 30 to 70 % |
| Engine coolant temperature | 70°C (158°F) or more |
| Intake air temperature sensor circuit | OK |
| Engine coolant temperature sensor circuit | OK |
| Crankshaft position sensor circuit | OK |
| Throttle position sensor circuit | OK |
| EVAP system pressure sensor circuit | OK |
| EVAP leak detection pump | OK |
| EVAP system vent valve | OK |