LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2010 >> Matrix S, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Control System (2ZR-FE) (Service Information)) >> Crankshaft Position Sensor >> Removal >> Removal

Crankshaft Position Sensor: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE ENGINE UNDER COVER RH 
  2. REMOVE CRANK POSITION SENSOR 
    1. Disconnect the crank position sensor connector.
    2. Remove the bolt and crank position sensor.
      Fig 1: Locating Crankshaft Position Sensor And Bolt
      GTY161160Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals