DTC Summary

WARNING: This page is about a different variant/trim than selected.

DTC No.	Monitoring Item	Malfunction Detection Condition	Trouble Area	Detection Timing	Detection Logic
P2420	Vent valve stuck open (vent)	Following condition met during key-off EVAP monitor: EVAP pressure change when vent valve closed (ON) less than 0.3 kPa-g (2.25 mmHg-g)	Canister pump module (Reference orifice, leak detection pump, vent valve) Connector/wire harness (Canister pump module - ECM) ECM	While ignition switch off	2 trip

HINT:

The vent valve is built into the canister pump module.