Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever following DTCs are not present | None |
P2111 (THROTTLE ACTUATOR STUCK OPEN)
| All of following conditions are met: | - |
| System guard* judge condition | ON |
| Throttle actuator current | 2 A or more |
| Duty cycle to close throttle | 80% or more |
P2112 (THROTTLE ACTUATOR STUCK CLOSED)
| All of following conditions are met: | - |
| System guard* judge condition | ON |
| Throttle actuator current | 2 A or more |
| Duty cycle to open throttle | 80% or more |
| *System guard set when following conditions are met: | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor fail | Not detected |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 5.5 V or more |
| Throttle actuator fail | Not detected |