Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
| Either of following conditions is met | Condition 1 or 2 |
| 1. Frequency that both of following conditions (a) and (b) are met | 5 times or more |
| (a) Either of the following conditions (a) and (b) is met | Condition A or B |
| A. Engine rpm - Target engine rpm | Less than -100 rpm, or more than 150 rpm (A/C off and NSW off) |
| B. Engine speed - Target engine speed | Less than -100 rpm, or 200 rpm or more (A/C on or NSW on) |
| (b) Vehicle condition | Stop after vehicle was driven at 6.25 mph (10 km/n) or more |
| 2. Frequency that both of following conditions (c) and (d) are met | Once |
| Either of the following condition is met: | Condition A or B |
| A. Engine rpm - Target engine rpm | Less than -100 rpm, or more than 150 rpm (A/C off and NSW off) |
| B. Engine rpm - Target engine rpm | Less than -100 rpm, or 200 rpm or more (A/C on and NSW on) |
| (b) Idle air control flow rate learning value | 0.5 L/sec or less, or 6.1 L/sec or more |