Valve Body Assembly: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE ENGINE UNDER COVER LH
DRAIN AUTOMATIC TRANSAXLE FLUID
1. Remove the drain plug and gasket, and drain ATF.
2. Install a new gasket and the drain plug.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
1. Remove the 19 bolts and remove the oil pan and oil pan gasket.
  
  Fig 1: Identifying Oil Pan Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Some fluid will remain in the oil pan. Carefully remove the oil pan sub-assembly.
2. Remove the 2 magnets from the oil pan.
  
  Fig 2: Identifying Magnets From Oil Pan
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Examine the particles in the oil pan.
  
  Fig 3: Checking Chips And Particles In Pan
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.
    Result
    
    Steel (magnetic)
    
    bearing, gear and plate wear
    
    Brass (non-magnetic)
    
    bushing wear
REMOVE VALVE BODY OIL STRAINER ASSEMBLY
1. Remove the 3 bolts and remove the oil strainer.
  
  Fig 4: Locating Oil Strainer Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Be careful as some fluid will come out of the oil strainer.
2. Remove the oil strainer gasket from the oil strainer.
  
  Fig 5: Identifying Oil Strainer Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSMISSION VALVE BODY ASSEMBLY
1. Disconnect the 5 connectors.
  
  Fig 6: Identifying Transmission Valve Body Assembly Connector, Bolt And Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt and lock plate and remove the ATF temperature sensor.
3. Remove the 2 bolts and manual detent spring cover and manual detent spring.
  
  Fig 7: Identifying Bolts, Manual Detent Spring Cover And Detent Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 13 bolts and valve body assembly.
  
  Fig 8: Locating Valve Body Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Do not drop the check ball body, check ball body spring or accumulator piston.
5. Remove the check ball body and check ball body spring.
  
  Fig 9: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the 2 transaxle case 2nd brake gaskets.
  
  Fig 10: Identifying Apply Gaskets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MANUAL VALVE
1. Remove the manual valve from the valve body.
  
  Fig 11: Identifying Manual Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002