Differential Oil Seal: Replacement: Replacement

WARNING: This page is about a different variant/trim than selected.

REMOVE ENGINE UNDER COVER LH
REMOVE ENGINE UNDER COVER RH
DRAIN AUTOMATIC TRANSAXLE FLUID See step 2
REMOVE FRONT DRIVE SHAFT ASSEMBLY
Refer to REMOVAL
REMOVE NO. 1 TRANSAXLE CASE OIL SEAL
1. Using SST, remove the No. 1 transaxle case oil seal from the transaxle case.
  
  Fig 1: Removing No. 1 Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09308-00010
REMOVE NO. 2 TRANSAXLE CASE OIL SEAL
1. Using SST, remove the No. 2 transaxle case oil seal from the transaxle housing.
  
  Fig 2: Removing No. 2 Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09308-00010
INSTALL NO. 1 TRANSAXLE CASE OIL SEAL
1. Using SST and a hammer, install a new oil seal to the transaxle housing.
  
  Fig 3: Installing Oil Seal To Transaxle Housing Using SST And Hammer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09387-00010
  - SST: 09950-70010
    - 09951-07200
  Standard depth
  
  -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
  
  NOTE:
  Do not damage the oil seal lip.
2. Coat the lip of the oil seal with MP grease.
INSTALL NO. 2 TRANSAXLE CASE OIL SEAL
1. Using SST and a hammer, install a new oil seal to the transaxle case.
  
  Fig 4: Installing No. 2 Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09726-27012
    - 09726-02041
  - SST: 09950-70010
    - 09951-07200
  Standard depth
  
  2.2 to 3.2 mm (0.0866 to 0.126 in.)
  
  NOTE:
  Do not damage the oil seal lip.
2. Coat the lip of the oil seal with MP grease.
INSTALL FRONT DRIVE SHAFT ASSEMBLY
Refer to INSTALLATION
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT TRANSAXLE FLUID LEVEL See step 1
INSTALL ENGINE UNDER COVER LH
INSTALL ENGINE UNDER COVER RH