Transmission Wire: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
DRAIN AUTOMATIC TRANSAXLE FLUID
1. Remove the drain plug and gasket, and drain ATF.
2. Install a new gasket and the drain plug.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
REMOVE BATTERY (See REMOVAL )
REMOVE BATTERY CARRIER (See REMOVAL )
REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (See REMOVAL )
REMOVE ENGINE UNDER COVER LH
REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
1. Remove the 18 bolts, oil pan and gasket.
  NOTE: Some fluid will remain in the oil pan. Carefully remove the oil pan sub-assembly.
  
  Fig 1: Locating Oil Pan Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 magnets from the oil pan.
  
  Fig 2: Identifying Oil Pan Magnets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Examine particles in the pan.
  1. Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.
    Result:
    
    Steel (magnetic): bearing, gear and plate wear
    
    Brass (non-magnetic): bushing wear
    
    Fig 3: Examining Particles In Pan
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT TRANSMISSION WIRE
1. Disconnect the transmission wire from the 7 shift solenoid valve connectors.
2. Remove the bolt and lock plate, and disconnect the ATF temperature sensor.
  
  Fig 4: Locating Shift Solenoid Valve Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSMISSION WIRE
1. Disconnect the transmission wire connector.
2. Remove the bolt and transmission wire.
  
  Fig 5: Locating Transmission Wire Connector And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the O-ring from the transmission wire.
Fig 6: Locating O-Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002