CLUTCH RELEASE CYLINDER (for E351): Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE RELEASE CYLINDER HEAT INSULATOR (See REMOVAL )
REMOVE CLUTCH ACCUMULATOR BRACKET (See REMOVAL )
DISCONNECT CLUTCH LINE
1. Using a union nut wrench (10 mm), disconnect the clutch line.
  
  Fig 1: Disconnecting Clutch Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT CLUTCH ACCUMULATOR ASSEMBLY
1. Remove the bolt and 2 nuts, and disconnect the clutch accumulator assembly and clutch tube bracket.
  
  Fig 2: Locating Clutch Accumulator Assembly Bolt And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY
1. Remove the 2 bolts and clutch release cylinder assembly.