How To Proceed With Troubleshooting

HINT:

• Use the following procedure to troubleshoot the air conditioning system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 
   1. Inspect the battery voltage.

      Standard voltage: 

      11 to 14 V 

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

   B:  Go to CAN COMMUNICATION SYSTEM

   A: Go to Next Step 

4. CHECK FOR DTC* 
   1. Check for DTCs and note any codes that are output.

      HINT:

      Refer to DTC Check / Clear (See DTC CHECK / CLEAR ).

   2. Clear the DTCs.
   3. Recheck for DTCs. Based on the DTCs output above, try to force the A/C system to output DTCs by simulating the conditions indicated by the DTC.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B: Go to step  7

   A: Go to Next Step 

5. PROBLEM SYMPTOMS TABLE 
   1. Refer to Problem Symptoms Table (See PROBLEM SYMPTOMS TABLE ).

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  7

   A: Go to Next Step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Data List / Active Test (See DATA LIST / ACTIVE TEST )
   2. Terminals of ECU (See TERMINALS OF ECU )
   3. On-Vehicle Inspection
   4. Inspection
7. ADJUST, REPAIR OR REPLACE